CAS-7100SA

cas7100sa 
cas7100sadraw 

SPECIFICATION
   CAS 7000 - Specifications
ITEM Specification
  CAPACITOR SIZES  

Diameter

Case Legnth
Φ25 - Φ45 (Φ50)   25 - 110mm (120)
2, 3, 4 Terminal
  AGING TIME   180-210min.
  PRODUCTION RATE   20pcs/min.
  AGING TEMPERATURE   85 - 105°C ±10°C
  AGING POWER SUPPLY   DC3 - 600V 
(AGPS : 600V 5A -12 SET) (Inner Voltage : 600V 5A) 
(LCPS : 600V 5A - 1 SET) (OP-SH 100V 5A)
  JIG QUANTITY  

245pcs (15pcs per JIG) Attached PTD

  TEST ITEM   OP-SH : DC3V - 100V Free Setting 
LC : 4µA/ 40µA / 400µA/ 4mA - 5Ranges 
CX : 0.2µF/ 2µF/ 20µF/ 200µF/ 2mF/ 20mF/ 100mF - 7Ranges 
DX : 0.01% - 100.00%  (50Hz or 60Hz)
*ESR : 100Hz, 120Hz - 0.01mΩ~99.99kΩ, 
                 1kHz       - 0.01mΩ~9.999kΩ 
  SORTING PROGRAM   GOOD, SH/OP, LC, CX, DX, ESR, TOTAL
  ADDITIONAL FUNCTION  

1)Polarity Alignment        2)Lot Change 
3)JIG Inspection              4)Sub Start Switch
5) Not Aging Inspection    6)1000H Timer Data Output 
7)LC, CX, DX(Manual Measurement of LC, CX and DX)

  AIR REQUIREMENT   5Kgf/cm2 90L/min
  POWER SUPPLY  

1)Driving Unit :
    AC 220V ±20V 3Phases 80KW 50Hz or 60Hz 
     *Heater : AC 220V ±20V 3Phases MAX 40KW
     *Rectifier : AC 220V ±20V 3Phases MAX 36KW
2)Testing Unit : 
    AC 110V ±10V 1Phase 2.5KW 50Hz or 60Hz

  MACHINE DIMENSION   8600(W) x 3150(D) x 1870(H) W=6500Kg
INTRODUCTION
This machine is for snap-in terminal type electrolytic-capacitors. 
Applicable capacitor sizes are Φ22 through Φ45. 
There are added function of marking system, injection ccd camera and sorting not-aged products.